Put Hot Tub Chemicals
When it comes to hot tub chemicals, the timing is extremely important. It is vital to remove the water from your spa after each use, and never leave it in for more than 12 hours. Before you start adding chemicals, you must wait for at least 30 minutes to allow them to dissolve. Once added, you must stir and drain the water thoroughly before enjoying a soak.
The exact time to add hot tub chemicals is dependent on the type of hot tub you have, as well as the amount of water. Some sanitizers are only required after a few months, while others require a more frequent dosage. Check the level of chlorine in your spa’s water before you put any chemicals in it.
Chlorine is a common option for keeping your hot tub clean. However, it can also be irritating to sensitive skin. In this case, bromine is a better choice. Bromine works at higher temperatures than chlorine and kills bacteria faster. It also has a lower pH than chlorine, which should help keep the water balanced.
When to Put Hot Tub Chemicals in Hot Tubs
The amount of bromine or chlorine needed for your hot tub depends on its total alkalinity level. You can use bromine tablets or liquid bromine. Either way, you should add one half ounce of water at a time. The concentration of free chlorine and bromine should be between three and five parts per million. To add a spa shock treatment, you can also add potassium monopersulfate.
You may also want to use a sanitiser. These sanitisers help keep your water clean and clear. They are fast acting, and are ideal for a short-term solution. The most common sanitisers include chlorine and bromine. These chemicals are effective at killing bacteria but can have side effects for some people. Another traditional method for treating hot tubs is to use chlorine granules. These are the cheapest, but they give off toxic gases that can burn or irritate skin.
You should also check the pH level of your hot tub water. A pH of seven to seven is the perfect range for hot tub water, and if it is too low or too high, you should add a pH increaser to bring it back into balance. This is important to maintain the pH levels of the water and avoid potential health issues.
The pH level of the water in your hot tub should be between 7.4 and 7.6 parts per million. If the pH level is too high, it can cause eye burn and cause scaling. Too low can cause cloudy water. So it’s best to check your hot tub water pH level twice a week, or every few months.